Description

Description：

This glass drill bit offers outstanding advantages, including sharp cutting performance, long-lasting durability, minimal edge chipping, high efficiency, and a high yield of finished glass drilling. It is an ideal choice for drilling household-appliance glass, electronic glass, shower enclosure glass, and architectural/building glass.

When using this drill bit, you must ensure sufficient internal water supply under adequate pressure. If conditions allow, external water spraying can also be added. The water pressure determines the cooling effect and chip/flushing performance when the diamond section rotates at high speed and rubs against the glass, which directly affects the drill bit’s service life and sharpness.

If, during use, you notice excessive edge chipping or reduced sharpness, you can re-sharpen the cutting edge using a #120–#140 white alumina (white corundum) grinding wheel, and then continue using the bit.

Please keep the feed rate within 1.5 mm per second for the first 100 holes. After 100 holes, you may gradually increase the feed rate. For the best performance and service life, please use the drill bit correctly. Thank you for your cooperation!

Our factory can customize special-purpose drill bits according to customer requirements, such as automotive glass drill bits, photovoltaic (PV) glass drill bits, and deep-hole crystal drill bits, and any size between 4-120mm, like 7.5mm,8.5mm,9.5mm, and so on. For special requirements like these, customization is required.

Please Note： 1. It is only used for fully automatic drilling machines and vertical drilling machines, not for hand drills. 2. Please cool with water when drilling